Do all this without the usb cable connected so you are just using bluetooth on its own. You say the cdp pairs with a password of 1234, so when it is paired look in device manager in control panel of windows 10 to find out what com port number the interface has been allocated, then go back to your Delphi software select usb/bt in the hardware setup section and then select the correct com port number, then hit the test button to see if it finds your interface. You may not have the correct com port number selected in the hardware setup section under settings in Delphi software, do you have usb/bt selected or bluetooth direct selected. Suggestion from folks in the MH community: So there must be some darn authentication mess up since updating to W10 When I click test connection in the event log I see…Īdministrative Events says :-The mutual authentication between the local Bluetooth adapter and a device with Bluetooth adapter address (aa:bb:cc:11:22:33) failed. The Multidiag Pro system says that the Com17/18(BT) Unknown device the system works using a USB lead in windows 10ĭevice manager says OBDII exists and is workingĭevice manager says Port (Com & LPT) Standard Serial over Bluetooth link (Com17/Com18) and is upto date.
Windows 10 Pairs the CDP ok and accepts a password of 1234 ok however, the hardware detection software in version 2013.3 fails to communicate. The Multidiag Prosystem was working via Bluetooth under windows 8.1.īut I cannot get Bluetooth to work since I upgraded to windows 10 Thread: Multidiag Pro Bluetooth CANNOT C onnect on WIN 10 Delphi Ds150e Usb Driver Windows 7 Download 64-bit.
0 kommentar(er)
